2. Using the Nokia Image Viewer for the
first time
1. Open the main unit by pushing the release bar (1).
Note: Always switch the power off and disconnect the
device from the charger ot any other enhancement
before opening the unit.
2. Lift the main unit cover up(2).
3. Unwrap the RCA connector cable from around the
battery cover (3). Remove the battery cover by sliding it
up as indicated by the arrow.
Using
the Nok
ia
Ima
g
e View
er fo
r
the first
time
13
Copyright
©
2004 Nokia. All rights reserved.
4. Insert the AAA batteries (4) and slide the cover back in
place.
5. Check that the NTSC/PAL switch (5) is in the correct
position.
6. Insert the MMC card (6) in the slot with the contact
surface towards the top of the main unit (where the
buttons are).
Lock the card in by pushing it in. To release the card,
push it slightly in again.
7. Make sure that the RCA cable is in the provided notch
(7) and close the main unit.
8. Install the remote control battery as shown in the
picture below.
The Nokia Image Viewer remote control uses the provided CR2032 button
battery as a source of power. If the remote control battery is out of power, you
Copyright
©
2004 Nokia. All rights reserved.
14
can use the Nokia Image Viewer by pressing the control buttons on the main
unit.
9. Connect the lead from the charger to the
socket at the back of the Nokia Image
Viewer and connect the charger to an AC
wall socket.
10.Press and hold
on the main unit to
switch on the Nokia Image Viewer.
11.Connect the RCA connector from the Nokia Image Viewer to a TV.
If your TV does not have a RCA connector, you need a RCA/SCART adapter,
which you can obtain from an electrical supply store. If you are using a wide
screen TV set, the TV screen should be set to a 4/3 ratio.
12.Open the RCA input channel in the TV. The Nokia logo is shown on the TV
screen when the correct channel is opened.
13.Unwrap the Pop-Port
TM
connector from the bottom of the main unit and
connect it to the compatible phone’s Pop-Port
TM
. Make sure that the phone is
switched on.
A progress bar is displayed on the TV while the images are transferred from the
phone. While the progress bar is displayed, pressing any of the buttons on the
main unit or the remote control will have no effect. If no progress bar is shown,
switch the phone off and then on again.
Note that after the Nokia Image Viewer has transferred the images in the
phone to its own internal memory, you can disconnect the phone from the
U
sing the
N
o
kia Image
V
iewe
r
15
Copyright
©
2004 Nokia. All rights reserved.
Pop-Port
TM
and still continue to view the images. When you connect a phone
to the Pop-Port
TM
again, the previously transferred images in the internal
memory are deleted.